GOB problems (Was: Call for contributions...)

[Hilaire Fernandes <hilaire@seul.org>]

 > > If so, can you describe the problem
 > > with the saving a figure because i don't notice it.
 > > 
 > 
 > Very simple in my case:
 > 
 >  * start Dr. Genius.
 > 
 >  * open a new figure, using the button in the toolbar.
 > 
 >  * create three free points.
 > 
 >  * try to save the figure from menu File/Save as...
 > 
 >  * Choose as a filename: toto.xml
 > 
 >  * An error dialog is displayed with the following message:
 > 
 >       Error saving to '/opt/work/gnome/dr-genius/toto.xml'
 > 
 >  * No toto.xml file is created.
 >  
 > That's it.  I'll try to run this under the debugger.

Ok, i didn't set back the save/save as facilities for figure. I always
use save session. However i just set it back but there is a weird
problem with gob, it's look like the drgenius_mdi_child_save doesn't
return the good value, so an error dialog alway raise even when save
is successfull.

George do you know why? I notice the same problem when saving a gelbuffer.

Hilaire