Re: gEDA-user: 2 newbie Qs

["John Luciani" <jluciani@xxxxxxxxx>]

On 9/6/06, Craig Niederberger <craigni@xxxxxxx> wrote:

> 2. In a linear array of pins, say one side of a DIP or a single row header,
> given a hole diameter H and an interpin distance D (commonly 0.1 inch or 2
> mm, but could be others,) are there any good suggestions for formulas for
> thickness T, mask M and clearance C?

I have the beginnings of a footprint design guide at

 http://www.luciani.org/not-quite-ready/doc/fp.pdf

When determining guidelines for copper width, pad spacing, etc. you
should survey
the process capabilities of the PCB houses that you are considering.
For DIPs and headers (100mil or 2mm centers) I usually size the
PADs to allow and 8mil trace with 8mil spacing.

(* jcl *)

--
http://www.luciani.org


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user