Re: gEDA-user: gEDA in space! :)

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Fri, 2008-09-12 at 11:21 +0400, Ineiev wrote:
> Hello, Alexander;
> 
> On 9/12/08, Alexander Gvozdev <alexander.gvozdev@xxxxxxxxx> wrote:
> >  My work place: http://arc.iki.rssi.ru/
> 
> I wonder where you print your gEDA-developped boards.
> 
> Once I tried marathon.ru, they told they couldn't produce
> negative apertures in polygons; I had to replace all thermal
> connections of vias with solid ones and do something similar
> with the pads. may.ru seem to have some problems, too.

IIRC..

Because this was a common problem (not supporting negative apertures),
PCB was switched over to using +ve only output. 

You might try the supplier you mentioned again, with a recent version of
PCB.

Best wishes,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user