Re: gEDA-user: atmega16 symbol error

[David Logan <djlogan2@xxxxxxxxxxx>]

DJ Delorie wrote:

> David Logan <djlogan2@xxxxxxxxxxx> writes:
>  
>
> > There is an error in the atmega16 gschem symbol. One pin reads "PD2
> > (OC1A)" when it should be PD5.
> >    
>
> There's another one on gedasymbols.org; see if it's correct.
>
> http://www.gedasymbols.org/user/ales_hvezda/symbols/ATmega16_TQFP.sym
>
>  
ok. Would this new symbol also stop gnetlist (when being run from 
gsch2pcb) from automatically and incorrectly assuming pin40=Vcc and 
pin20=GND ?

David Logan