[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: outline layer

> Related question:  How can I set how close the autorouter goes to the
> edges?   On my last board, it insisted on putting vias right next to
> the board outline.

The only way to control the autorouter at this point is to draw copper
on every layer where the outline is, so that it cannot cross it.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user