Re: gEDA-user: Layer confusion?

[Dave McGuire <mcguire@xxxxxxxxxxxxx>]

On Jul 31, 2005, at 5:21 PM, harry eaton wrote:
> >    Hi folks, PCB question here.  I seem to recall Harry and Bob
> > discussing this just a few days ago, but I think I've run into
> > something different.
>
> No, it is exactly the same. Bob was complaining about pads because
> he created the element from TRACES that were on the wrong side.
> As explained in the previous messages, you just need to put the layers
> on the correct side with a couple of check boxes. The problem is that
> the layered named 'component' in the default installation was on the 
> solder
> side of the board. The name of the layer has no meaning, the layer 
> grouping
> is what controls.

  Ahhhh ok, thanks for the explanation...I had misinterpreted Bob's 
earlier message.  Everything is fine now and my boards have been 
ordered.  Thanks for your help!

          -Dave

--
Dave McGuire             "I wonder what 'Error Code 1' means. That's
Cape Coral, FL            what it said when it started smoking."  
-Jonathan Patschke