[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: inverted pins?

To: geda-user@xxxxxxxx
Subject: Re: gEDA-user: inverted pins?
From: sdb@xxxxxxxxxx (Stuart Brorson)
Date: Sun, 19 Feb 2006 22:03:34 -0500 (EST)
Delivered-to: archiver@seul.org
Delivered-to: geda-user-outgoing@seul.org
Delivered-to: geda-user@seul.org
Delivery-date: Sun, 19 Feb 2006 22:03:38 -0500
In-reply-to: <200602200252.k1K2qkos031485@envy.delorie.com> from "DJ Delorie" at Feb 19, 2006 09:52:46 PM
Reply-to: geda-user@xxxxxxxx
Sender: owner-geda-user@xxxxxxxx

> > You are correct that gattrib expects to read schematic files, not
> > symbols.  What did it do when you read in a .sym file?  I hope it
> > didn't barf ...
> 
> Loading file [/envy/dj/house/furnace/pcb2/syms/cy7c1041b.sym]
> No components found in entire design!  
> Do you have refdeses on your components?  
> Exiting. . . .

Good!  That's what gattrib should do if you run it on a file which
isn't a schematic.  It used to simply segfault.  :-( 

Stuart

References:
- Re: gEDA-user: inverted pins?
  - From: DJ Delorie

Prev by Author: Re: gEDA-user: inverted pins?
Next by Author: Re: gEDA-user: inverted pins?
Previous by thread: Re: gEDA-user: inverted pins?
Next by thread: Re: gEDA-user: inverted pins?
Index(es):
- Author
- Thread