Re: gEDA-user: DIY brass stencils

[Ben Jackson <ben@xxxxxxx>]

On Wed, Feb 21, 2007 at 02:41:23PM -0500, DJ Delorie wrote:
> 
> DJ Delorie <dj@xxxxxxxxxxx> writes:
> > http://www.delorie.com/pcb/brass/
> 
> I added today's results to that page, too.

The next thing to try would be compensating the shapes for the distortion
caused by the etching.  You should try bowing in the sides of the openings
to see if you could square up the holes, like:

    __
   )__(

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user