Re: gEDA-user: vertical toolbox in gschem

[Rob Butts <r.butts2@xxxxxxxxx>]

   No Peter, I've never installed gEDA from rpm. I installed Fedora 14 and
   then through the software manager installed the gEDA software. I take
   it a vertical menu bar is not possible to configure in the gschemrc
   file?

   At some point I'd like to figure out the whole cvs gEDA thing.

   On Sun, Feb 6, 2011 at 3:09 PM, Peter Clifton <[1]pcjc2@xxxxxxxxx>
   wrote:

   On Sun, 2011-02-06 at 10:29 -0500, Rob Butts wrote:
   > What do Celine Tschida with vertical_toolbar.patch?  Is there
   something you can
   >    do to the gschemrc file?

     It was a patch against the source-code, so you would have to apply
     it to
     a checked out version of the gEDA sources and rebuild / install from
     source.
     Do you install gEDA from RPMs?
     --
     Peter Clifton
     Electrical Engineering Division,
     Engineering Department,
     University of Cambridge,
     9, JJ Thomson Avenue,
     Cambridge
     CB3 0FA
     Tel: +44 (0)7729 980173 - (No signal in the lab!)
     Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)
     _______________________________________________
     geda-user mailing list
     [2]geda-user@xxxxxxxxxxxxxx
     [3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References

   1. mailto:pcjc2@xxxxxxxxx
   2. mailto:geda-user@xxxxxxxxxxxxxx
   3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user