gEDA-user: PCB Auto-Router Misroutes

[Stephen W Morss <swm@xxxxxxxxxxxxx>]

I'm using PCB 1.99q to do a board layout and am trying to use the router.  I'm finding that it has a
tendency to short different nets together.  Even after I do a route and clean up shorted nets, if I rerun
the router, other shorts are generated.  It's strange because when I hit "O" to optimize routes, PCB
points out all the shorted nets.  Once I delete the shorts, the rats nest doesn't show the shorts
either.  It's as though the rats nester and router are out of sink, each seeing the needed connections
differently (though the rats nest looks right and some of the routes are clearly wrong).  Has anyone else
seen/solved this problem.

Thanks,
Steve 
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user