Re: gEDA-user: Footprints with mil and mm grid on same pcb

[DJ Delorie <dj@xxxxxxxxxxx>]

> What is the correct and CLEAN way to connect components/footprints
> with these incompatible grid-sizes?

Try turning "orthgonal moves" on.  Then, when you snap to the off-grid
pin, it snaps the corner instead.  A second click, and you have a
clean connection.

> Can the combination of mm- and mil-footprints lead to problems when
> I create gerber files for board fabrication?

No, because everything is converted to one unit, which is some
fraction of a mil in PCB, during export.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user