[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: PCB from cvs



Levente wrote:
Note that you should put into the README.* that automake 1.9.x is required, hence I tested with 1.7, and it was not working properly.

Levente



I just changed this (in README.cvs):

automake  -- ftp://ftp.gnu.org/pub/gnu/automake/
             The developers use the 1.9.* versions of automake.  Older
             versions have not been as well tested (or tested at all).

to this:

automake  -- ftp://ftp.gnu.org/pub/gnu/automake/
             The developers use the 1.9.* versions of automake.  Older
             versions have not been as well tested (or tested at all).
             Versions 1.7 and older are too old and will not work.

-Dan


_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user