Re: gEDA-user: Can't vertically mirror in PCB

[Dave N6NZ <n6nz@xxxxxxxx>]

I must be missing something.... can you order mirrored parts from 
DigiKey by typing the part number in backwards, or is there more to it 
than that?

-dave

Robert Butts wrote:
> Because traces coming from a connector are criss-crossing.  Mirroring the IC
> will fix this.  I have to keep all the components on the same side.
> 
> On Fri, Jul 25, 2008 at 5:55 PM, Eric Brombaugh <ebrombaugh1@xxxxxxx> wrote:
> 
>> Robert Butts wrote:
>>> I'm trying to vertically mirror a chip in PCB.  I select the IC, cut it
>>> to the buffer, mirror buffer and click on the board again and the IC
>>> doesn't change.  What am I doing wrong?
>> Why do you want to mirror an IC?
>>
>> If you're trying to place it on the back side of the board, use the tab
>> and/or 'b' options.
>>
>> Eric
>>
>>
>> _______________________________________________
>> geda-user mailing list
>> geda-user@xxxxxxxxxxxxxx
>> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>>
> 
> 
> ------------------------------------------------------------------------
> 
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user