Re: gEDA-user: Place part outside of board outline

[Philipp Klaus Krause <pkk@xxxxxxx>]

Tamas Szabo schrieb:
> Hello All,
> 
> I would like to place a connector to the PCB but I'm unable to put it to 
> the right position, since no part of the connector can be over the board 
> outline specified in preferences. I realized it earlier but now it 
> became significant.
> 
> Is there a way to workaround it? (Not counting the possibility to 
> specify the board size bigger and creating an outline inside it. Or 
> should be the solution is this?)
> 
> Thanks in advance,
> 

Make the board bigger, place connector, change the size to the final
size. The connectorjust stays were it is. I just tried with a capacitor,
seemed to work fine (I didn't export gerbers though).

Philipp



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user