[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Any-to-one connections

Philipp Klaus Krause wrote: 
I'm currently drawing a schematic using gschem. There's a GAL in it and
some other chips. Since the GAL's outputs /inputs are all equivalent I
don't care which output is used for some task. For example I want to
feed a GAL output into the output enable of an EPROM. So I want one of
the GAL's outputs connected to the OE input of the EPROM, but I don't
care which one is used. Is there a way to tell gschem about this?
Depending on which output is used the resulting pcb would use a
different number of vias, etc.

Philipp


I do the following:
1. Assign all I/O in the schematic.
2. Generate a pcb file.
3. Look at the layout at point out potential problems.
4. Go back and alter the schematic connections.
5. Regenerate the pcb file (just a new net file).
6. Load the altered net into the existing pcb layout.
7. Repeat until satisfied.

I don't know how you could tell gschem that you don't care about connections? What would your final schematic look like?

Ryan

_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user