Re: gEDA-user: using buses in gschem

[michalwd1979 <michalwd1979@xxxxx>]

Thanks for reply.
I have converted my design, however naming nets is more problematic than those bus connection symbols, mostly because of placement of the text. With \_ symbol netname= attribute is always near bus (where I want it), with nets it is not. I red that that buses are new - is this the final way of handling them or are there any planned changes? I did not say that the current way is bad, just wanted to know.

Best Regards,
Michael W.


Dnia 4 maja 2008 15:32 Ales Hvezda <ahvezda@xxxxxxxxxxxxxx> napisał(a):

> 
> >> Hello,
> >>  I have created a schematic with buses on it, however after drc I found that
> > buses are not connected.
> >>  When I connect a net to a bus gschem draws a nice bus connection symbol (lo
> >oks like \_). I added a netname=something attribute to these symbols to connec
> >t right pins but it seems that they were ignored. What I have done wrong? Or m
> >aybe I should ask: what is an official way of using buses in gschem?
> >
> >The bus is only graphical. You need to have a named net at each end of
> >a connection.
> >
> 
> 	... by putting the netname= attribute on the net instead of the
> bus junction \_ symbol.  
> 
> 								-Ales
> 
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
> 


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user