[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: terminators

On May 3, 2009, at 8:36 PM, DJ Delorie wrote:
>>    So, 10-15 minutes?  =)
>
> Not quite *that* fast.  A couple min to print, 2 min for expose, 15
> min to harden, 10 min to develop, 5-10 min to etch, 3-4 min to strip.
> That's per layer, but the steps can overlap.  Assuming I don't have to
> redo any of the layers.
>
> Then add drill time, paste, and component placement.  4 min to reflow.
> Then I have to solder all the vias and through-hole parts.

   I'm sure you could shave a few minutes off of those times with  
enough caffeine. ;)

             -Dave

-- 
Dave McGuire
Port Charlotte, FL



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user