gEDA-user: ??Error message PCB??

[Ernst van Spronsen <evanspronsen@xxxxxxxxx>]

   Hello,
    I have a problem while converting my schematic too pcb.
    I have made a schematic with gschem and converted it with gsch2pcb .
    When I start up my new created pcb file I got the following error
   message from the program PCB:

   Looking for default_font in .
   Can't open ./default_font for reading
   Looking for default_font in /usr/bin/../share/pcb
   Found default_font in /usr/bin/../share/pcb
   ERROR parsing file 'DigitalPowerSupply.pcb'
       line:        117
       description: 'syntax error'
   The gtk gui currently ignores "grey50"as part of a menuitem resource.
   Feel free to provide patches
   ghid_load_menus():  Mouse resources are currently ignored by the GTK
   HID.
   Please feel free to submit a patch to implement this!
   ----------------------------------
   This is on line 117=>  ).fp(1210.fp,M1/L4,4.7uH/0.9A/0.2R)
   Below is a snap of the file.
   # This draws a 1 mil placement courtyard outline in silk.  It should
   probably
   # not be included since you wont want to try and fab a 1 mil silk
   line.  Then
   # again, it is most useful during parts placement.  It really is time
   for some
   # additional non-fab layers...
   #       ElementLine[eval(-1*V1/2) eval(-1*V2/2) eval(-1*V1/2) eval(
   V2/2) CYW]
   #       ElementLine[eval(-1*V1/2) eval(-1*V2/2) eval(   V1/2)
   eval(-1*V2/2) CYW]
   #       ElementLine[eval(   V1/2) eval(   V2/2) eval(   V1/2)
   eval(-1*V2/2) CYW]
   #       ElementLine[eval(   V1/2) eval(   V2/2) eval(-1*V1/2) eval(
   V2/2) CYW]
   ).fp(1210.fp,M1/L4,4.7uH/0.9A/0.2R)
   # grab the input values and convert to 1/100 mil
   -------------------------------------------
   Can you please tell me what the problem is?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user