[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: no pins in JUMPER10

Hi there,

I've made an schematic with a "pin bar" that has "JUMPER10" as footprint.
But when I export it to PCB none of the pins on it get connected.
The rest of my circuit is ok, but the "JUMPER10" components goes
disconnected in PCB.

Any advice?
Thank you guys.
[]'s


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user