Re: gEDA-user: Howto make solder mask extend equal for all pads in layout?

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Samstag, den 04.10.2008, 10:07 -0400 schrieb DJ Delorie:
> There is a MinMaskGap() action to increase the mask gap to vendor
> minimums.  What you can do is this:
> 
> * Enable the mask layer
> 
> * Select everything that needs the mask set
> 
> * Use Ctrl-Shift-K to reduce the mask as much as you can for
>   everything selected
> 
> * :MinMaskGap(Selected,=8,mil) to increase them all to that amount
> 

Great!

Is there something similar for copper clearing of pads/pins in polygons?


> If you're adventurous, you could look up the sources for MinMaskGap()
> and add a SetMaskGap() that does the same thing, but forces it to a
> specific value.  Should be relatively easy.

At least I will create a feature request for sourceforge bugtracker.

Thanks

Stefan Salewski




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user