On Tue, 2008-10-07 at 18:34 +0200, Stefan Salewski wrote: > Am Montag, den 06.10.2008, 10:55 -0700 schrieb Ben Jackson: > > > > Is it possible you optimized the ratlist while they were over a polygon > > and then moved them? The ratlist never reevaluates due to dragging a part. > > For normal rats this just means less optimal lines running around, but if > > you have a 'via rat' it will persist even after the drag until you hit 'O' > > again. > > > > You may have a plane on a layer you turned off. I haven't looked at the > > PCB file. > > > > I think it is really a bug of version 20080202. > > Currently this bug is not a big problem for me, because I have replaced > all planes with thick lines. But I will need more planes soon... > > Maybe someone can test with cvs head. I will myself make a test with a > layout created from scratch. I'd be interested to see this test-case too. I'm sure I've hit similar problems. It "might" in my case, have picked up saying "yes, I'm inside this huge polygon", where actually, half of it was cleared away by other tracking. See the attached test file. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!)
Attachment:
test.pcb
Description: application/pcb-layout
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user