Re: gEDA-user: I am doing something wrong in PCB

[Kipton Moravec <kip@xxxxxxxxxx>]

On Sun, 2008-10-26 at 15:29 +0100, Stefan Salewski wrote:
> Am Sonntag, den 26.10.2008, 08:19 -0500 schrieb Kipton Moravec:
> > I take that back. Some of the lines are there, but they seem the size of
> > the rats nest lines. How do I display them so they look like a trace
> > with the correct width?
> > 
> 
> In GTK GUI there is a knob "Route Style" in lower left window area.
> 
> Please see the fine tutorial of DJ Delorie too:
> 
> http://www.delorie.com/pcb/docs/gs/gs.html
> 
> 

That tutorial also seems to show that the traces are different than what
I am drawing.

When I draw a thick trace that is 40 mils wide using the thick "Route
Style" why does DJ tutorial show traces as I expect and my traces are
the same thickness as rats nest lines?

When I start to draw it, the outline is the proper thickness. (40 mils
for example) when I finish, it is the size of a rats nest line. I am
assuming some type of mode switch is in the wrong position, but I can't
figure out what it is called or where it is.

-- 
Kipton Moravec AE5IB
"Always do right; this will gratify some people and astonish the rest."
--Mark Twain




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user