Re: gEDA-user: trouble with DRC checker

["Mark Rages" <markrages@xxxxxxxxx>]

On Sat, Oct 25, 2008 at 4:45 PM, DJ Delorie <dj@xxxxxxxxxxx> wrote:
>
> Check your "shrink" size.  In your case, it's set to 10 mil, which
> means any two touching copper segments must overlap by at least 10
> mil.  You have some segments that only overlap by 3 mil.
>
> You can set this smaller if your process doesn't care about checking
> for misaligned segments causing opens (old photoplotters drew each
> segment mechanically, new processes almost always rasterize and don't
> need to check for shrink).
>

OK, that helps a lot.  Thank you.

Regards,
Mark
markrages@gmail

-- 
Mark Rages, Engineer
Midwest Telecine LLC
markrages@xxxxxxxxxxxxxxxxxxx


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user