gEDA-user: pcb outline clarification

[gene glick <carzrgr8@xxxxxxxxxxxxx>]

My design creates an outline layer.  The rectangle the represents the 
outline of my board is about 11" X 11".  The drawing area is about 20" X 
14".  In the fab.gbr layer, there is a note at the very bottom stating 
"Board outline is the centerline of this 10 mil rectangle - 0,0 to 
20000,14000 mils".  Is that going to confuse the PCB manufacturer?  I 
want them to cut along the lines on the outline layer, not the fab layer.

thanks


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user