Re: gEDA-user: [pcb] MinMaskGap action

[joeft <joeft@xxxxxxxxxxxxx>]

Phil,

You didn't mention whether this was "incidental" silkscreen like a 
"ElementLine" that overlapped the pad or something related to the pad 
itself..  A previous version of pcb would in some cases generate 
silkscreen rectangles in the gerber output on some surface mount pads.  
I was never able to figure out what combination(s) of features would 
cause this to happen, but it does appear to be fixed in the most recent 
revision of pcb.  (You can and should look pretty carefully at your 
gerber output to make sure it is correct.)

Joe


ptay wrote:

> DJ,
>
> About a year ago I got some boards back with silkscreen printed over 
> some pads.  Since, I've manually kept the silkscreen off the pads.  
> ... Does MinMaskGap work on silk too?
>
> Phil
>
>
>
> DJ Delorie wrote:
>
> > F.1.41 MinMaskGap
> >
> > MinMaskGap(delta)
> > MinMaskGap(Selected, delta)
> > Ensures the mask is a minimum distance from pins and pads.  Checks all
> > specified pins and/or pads, and increases the mask if needed to ensure
> > a minimum distance between the pin or pad edge and the mask edge.
> >
> >
> > _______________________________________________
> > geda-user mailing list
> > geda-user@xxxxxxxxxxxxxx
> > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user