Re: gEDA-user: PCB, clearance around square pads in planes

[Stephan Boettcher <boettcher@xxxxxxxxxxxxxxxxxx>]

DJ Delorie <dj@xxxxxxxxxxx> writes:

>> later versions of PCB make the clearance in a plane around a
>> rectangular pad with rounded corners.  Is there a way/flag to turn
>> that back to the old behaviour, to get rectangular clearance?
>
> No.  See http://www.delorie.com/pcb/notches.html

I remember that this was discussed in -devel a while back.  This is
unfortunate.  I cannot open the design files and get the same results
as before.  This makes the space flight QA people a bit nervous.

Secondly, I have some design rules that are difficult to meet with
these round holes.

I understand why you want them, but you may want to know that I very
much do not want those corners to be round.

Cheers
Stephan


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user