gEDA-user: Adding extra layer

[Neil Webster <nwebster@xxxxxxxxxxx>]

I have a 10 layer pcb that I have just completed routing. I need to
create a board outline with some notches etc and when I try to add an
extra layer for the outline I can not, as I am maxed out at the 16 layer
limit (i.e. 10 routing layers + silk + rats + pads + vias + far side +
solder mask).

I have read a couple of posts about a patch and a compile switch to
enable extra layers. What is the best approach to achieve this?

Regards, Neil



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user