Re: gEDA-user: PCB: build error from CVS

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Thu, 2008-09-11 at 09:57 -0700, Dave N6NZ wrote:
> Dan McMahill wrote:
> > Dave N6NZ wrote:
> >> Just did a pull of pcb from CVS for the first time in a long time.  
> >> The build in a fresh directory failed building documentation.
> >>
> >> It appears that pcb.texi references pad.txt thermal.txt pad.png and 
> >> thermal.png which are no where to be found.  Since the binary built OK 
> >> (which is what I was interested in) I didn't spend more than 7 seconds 
> >> on diagnosis, but I suspect that these are new files that have not 
> >> been pushed to the repo but the references have been.  OTOH, I do have 
> >> a 'git cvsimport' command in between, so there could be a glitch in 
> >> that step.
> > 
> > read README.cvs and it has the answer.
> 
> All the requirements appear to be there.
> 
> Another clue, please.

--enable-maintainer-more or --disable-docs

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user