[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: determining which are the ORs a Tor circuit is using
I taking the following route
circuitbuild.c-> circuit_send_next_onionskin->
At the point where there is a check for if(!hop)
I take the 'circ' pointer and -> crypt_path_t pointer ->
extend_info_t pointer -> nickname/addr
Should that work ?
Thanks
Sambuddho
On Tue, 2008-11-11 at 12:55 -0700, mrwigglet wrote:
> I know it is saved in the log files, although there may be an easier
> way to do it. There are lots of paths built that are in a waiting
> state, so you'd have to do some connecting the actual circuit being
> used with when it was built. I don't know of a built in way of doing
> this.
>
>
> On Tue, Nov 11, 2008 at 12:50 PM, Sambuddho Chakravarty
> <sc2516@xxxxxxxxxxxx> wrote:
> Hello All
> I have a general question. I am using the default torrc
> (without
> specifying which ORs to select and letting the client
> determine the
> "best" ones for itself). Is there a way to detect which are
> the ORs the
> client picks up for the entry , middleman and exit nodes
> (rather than
> hacking into the source code of the tor client). I am using a
> rather
> dated version of the client - 0.1.2.18.
>
> Thanks
> Sambuddho
>
>
>
>
> --
> Nathan Evans
> Research Assistant
> Department of Computer Science
> University of Denver