[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Layer selection screw-up

To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: Layer selection screw-up
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Wed, 21 Mar 2007 16:16:31 -0400
Delivered-to: archiver@seul.org
Delivered-to: geda-user@moria.seul.org
Delivery-date: Wed, 21 Mar 2007 16:16:46 -0400
In-reply-to: <46018EDC.5030805@naic.edu> (message from Ryan Seal on Wed, 21 Mar 2007 16:00:28 -0400)
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <46018EDC.5030805@naic.edu>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

You could just rename the layers, then rearrange them in the order you
want.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: Layer selection screw-up
  - From: Ryan Seal

Prev by Author: Re: gEDA-user: gEDA vs commercial product
Next by Author: Re: gEDA-user: PCB gerber exporter question
Previous by thread: Re: gEDA-user: Layer selection screw-up
Next by thread: gEDA-user: PCB gerber exporter question
Index(es):
- Author
- Thread