Re: gEDA-user: ARDUINO design using GEDA

[Bert Timmerman <bert.timmerman@xxxxxxxxx>]

Hi,

Looks nice :)

Better avoid for text as copper on component side.

A lot of resistors with refdes "R1", capacitors with "C7", no refdesses
on connectors, etc.

I bet you didn't use the "gschem -> gsch2pcb  -> pcb" tool chain.

My EUR 0.02

Kind regards,

Bert Timmerman.

On Sat, 2009-03-14 at 03:21 -0700, jeffrey antony wrote:
>    Hi...
>    This is one of my designs that I have done using gEDA. The board is
>    Arduino single sided serial board.
>    Please read this page [1]http://jeffrey.co.in/gnudino/
>    If there is any mistakes please point out
>    JEFFREY ANTONY
> 
> References
> 
>    1. http://jeffrey.co.in/gnudino/
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user