[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: ARDUINO design using GEDA

To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: ARDUINO design using GEDA
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Sat, 14 Mar 2009 12:24:35 -0400
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Sat, 14 Mar 2009 12:24:53 -0400
In-reply-to: <914232.5712.qm@xxxxxxxxxxxxxxxxxxxxxxxxxxx> (message from jeffrey antony on Sat, 14 Mar 2009 03:21:47 -0700 (PDT))
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <914232.5712.qm@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

> Please read this page http://jeffrey.co.in/gnudino/
> If there is any mistakes please point out

If my interpretation of your board is correct, you've put all the
components on the same side of the board as all the copper.

Check your drill sizes; 20 mil for an axial diode seems too small to
me.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: ARDUINO design using GEDA
  - From: jeffrey antony

Prev by Author: Re: gEDA-user: PCB: connect line to rectangle
Next by Author: Re: gEDA-user: Converting square/circular pads to oval(elliptical) pads
Previous by thread: Re: gEDA-user: ARDUINO design using GEDA
Next by thread: gEDA-user: Gnetlist can't find files?
Index(es):
- Author
- Thread