[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
gEDA-bug: [ geda-Bugs-2470098 ] LCD and PIC16F876 symbols
Bugs item #2470098, was opened at 2008-12-27 03:54
Message generated for change (Tracker Item Submitted) made by Item Submitter
You can respond by visiting:
https://sourceforge.net/tracker/?func=detail&atid=818426&aid=2470098&group_id=161080
Please note that this message will contain a full copy of the comment thread,
including the initial issue submission, for this request,
not just the latest update.
Category: symbols
Group: None
Status: Open
Resolution: None
Priority: 5
Private: No
Submitted By: Nobody/Anonymous (nobody)
Assigned to: Nobody/Anonymous (nobody)
Summary: LCD and PIC16F876 symbols
Initial Comment:
Hi all,
I just installed gEDA and I noticed a few bugs with some symbols. Specifically:
A) The LCD module symbol has a pin marked (R/W) with an overbar over the R. The overbar should be over the W as a LOW indicates write mode on most LCD modules.
B) The LCD symbol's pins do not seem to be on-grid when the default 100x100 grid is used.
C) The symbol for the PIC16F876 has two pins labeled RA5. Pin 5 should be RA3 instead of RA5.
It took me a while to realize that I had to be root to edit the default schematic symbols. I tried to fix the problem with the PIC16F876 and whenever I clicked "Save", I wouldn't get any error message - it just wouldn't update the symbol. Also, it wouldn't let me quit unless I said "quit without saving". Clicking "save then quit" would still not give any error message, just go right back to the editor without quitting.
Thanks for this great EDA effort!
Sean Breheny
shb7@xxxxxxxxxxx
----------------------------------------------------------------------
You can respond by visiting:
https://sourceforge.net/tracker/?func=detail&atid=818426&aid=2470098&group_id=161080
_______________________________________________
geda-bug mailing list
geda-bug@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-bug