[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
gEDA-bug: [Bug 698592] Re: protelII backend uses LF, but protel requires CR+LF
** Bug watch added: Debian Bug tracker #562641
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=562641
** Also affects: pcb (Debian) via
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=562641
Importance: Unknown
Status: Unknown
** Bug watch added: Debian Bug tracker #169746
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=169746
** Changed in: pcb (Debian)
Remote watch: Debian Bug tracker #562641 => Debian Bug tracker #169746
--
You received this bug notification because you are a member of gEDA Bug
Team, which is subscribed to gEDA.
https://bugs.launchpad.net/bugs/698592
Title:
protelII backend uses LF, but protel requires CR+LF
Status in GPL Electronic Design Automation tools:
Fix Released
Status in âpcbâ package in Debian:
Unknown
Bug description:
Hello,
This was reported by a Debian user:
If I generate a sch with gschem and use:
gnetlist -g protelII -o test.net test.sch
then try to load the netlist in protel, it just says that there are no components in the netlist.
If I use: unix2dos test.net
then protel understand the netlist without any problem. I think it
would be good to generate the output file with DOS line terminators
(CR+LF) in protelII backend, as protel does not understand LF only.
_______________________________________________
geda-bug mailing list
geda-bug@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-bug