Re: gEDA-user: Looking for a project

[Tomaz Solc <tomaz.solc@xxxxxxxxxx>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi

> I'd like to see your bill of materials and design for that Tomaz.  It's
> the start of some ethernet labview-like gear.

I'm afraid it doesn't work over the ethernet. It only uses the ethernet
card as a cheap interface to the computer's PCI bus.

Here are the schematics: http://www.tablix.org/~avian/gnuradio

adc.eps is the board with the A/D converter, FIFO buffer and supporting
logic. I have this on a separate circuit board. It is then connected
with a flat cable to a smaller digital circuit inside the computer that
sits on the ethernet card.

8139d_if.eps is the circuit that is connected to a RTL8193D-based
ethernet card. The connector on the top left is plugged into the
Boot-ROM socket. You also need to connect the circuit to the INTA# line
on the card.

I also have some basic Linux drivers written for this thing.

Best regards
Tomaz
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFGD48LsAlAlRhL9q8RAqmaAJ9eoJvmFDlSYWwYpktzYd5y1ReUxgCgztMR
Cso8JxYP7Pef3nr8hF0RWtc=
=evap
-----END PGP SIGNATURE-----


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user