Re: gEDA-user: the joy and sadness of new boards

[John Luciani <jluciani@xxxxxxxxx>]

On Wed, Apr 1, 2009 at 7:43 PM, Darrell Harmon <dlharmon@xxxxxxxxxxxx> wrote:
> I recently ordered a batch of 4 layer boards from 66each and was able
> to get 7 different boards on the panel. I made a router table from my
> Dremel tool from MDF and used an 0.031" carbide end mill set to cut
> about half way through the board. After routing both sides, the edges
> I routed are hard to tell from the ones Advanced Circuits routed. The
> FR4 dust was bad, so you may want to wear a mask if you do it this
> way.

Do you have a picture of your setup?

Any idea how many linear inches you get per end mill?

(* jcl *)

-- 

You can't create open hardware with closed EDA tools.

http://www.luciani.org


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user