[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: rat width

To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Subject: gEDA-user: rat width
From: Mark Rages <markrages@xxxxxxxxx>
Date: Thu, 2 Apr 2009 17:56:40 -0500
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Thu, 02 Apr 2009 18:56:49 -0400
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

I am working on a design with a lot of small parts and pcb's default
rat width is too wide to see what I'm doing.  I don't see a setting
for this.  Where should I look?

Regards,
Mark
markrages@gmail
-- 
Mark Rages, Engineer
Midwest Telecine LLC
markrages@xxxxxxxxxxxxxxxxxxx


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: rat width
  - From: Ben Jackson
- Re: gEDA-user: rat width
  - From: DJ Delorie

Prev by Author: Re: gEDA-user: silk on other side of board
Next by Author: Re: gEDA-user: outline layer
Previous by thread: Re: gEDA-user: start up options
Next by thread: Re: gEDA-user: rat width
Index(es):
- Author
- Thread