gEDA-user: OT: I2C pullup resistor location

[Jim <jim@xxxxxxxxx>]

I'm building a backplane board that will have a processor board (master) 
and 8 slaves using I2C across the backplane.  Is there any advantage to 
placing the pullup resistors on the end of the backplane farthest from 
the processor board?  I recall installing active termination on the old 
S-100 bus backplanes to overcome problems with ringing, I think.  It's 
been too long. 

Thanks,
Jim.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user