Re: gEDA-user: un-tented vias and solder mask

[timecop <timecop@xxxxxxxxx>]

Thats funny, i'd rather HAVE my vias covered with solder mask.


On Fri, Apr 16, 2010 at 7:51 PM, Richard de Rivaz <richard@xxxxxxxxx> wrote:
>   Hi
>   I have a similar problem. I am using pcb v20080202-2 on Ubuntu and have
>   found that certain pads do not appear in the solder mask when exported
>   as Gerber files. I wonder if anyone else has come across this problem
>   and any way of forcing all pads to be included.
>   Regards Richard
>   kai-martin knaak wrote:
>
>     Hi.
>     I like to have my vias non tented. That is, little holes in the
>     solder mask,
>     so that some bare metal is exposed. This comes handy for debugging.
>     Is it
>     possible to configure pcb so that vias are exposed by default?
>     ---<)kaimartin(>---
>     --
>     Kai-Martin Knaak
>     Ãffentlicher PGP-Schlüssel:
>     [1]http://pgp.mit.edu:11371/pks/lookup?op=get&search=0x6C0B9F53
>     _______________________________________________
>     geda-user mailing list
>     [2]geda-user@xxxxxxxxxxxxxx
>     [3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>   --
>
>   Richard de Rivaz
>   MDR Interfaces Ltd
>   Network Security, Email, Web Services, LiveSign^® Digital Signage and
>   Computer Control Specialists
>   Tel: +44(0)1825 790294 Fax: +44(0)1825 790119
>   Reg in England No. 1577056 Directors: R de Rivaz  Z de Rivaz
>   Reg Address: Little Bridge House, Danehill, Sussex RH17 7JD
>   http://www.mdr.co.uk
>
> References
>
>   1. http://pgp.mit.edu/
>   2. mailto:geda-user@xxxxxxxxxxxxxx
>   3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user