Re: gEDA-user: xgsch2pcb acts different from gsch2pcb

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2010-04-24 at 06:04 -0400, Jim wrote:
> If I take my project.rc file and copy it to project.gsch2pcb and
> change 
> the output-name to something else so I don't clobber my ongoing 
> development and run xgsch2pcb, pcb then gives me a bunch of errors 

Did you copy your board as well, or are you starting from a blank one?

Try hitting "O" after opening the board you run gsch2pcb manually on..
does it have any messages then?

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user