[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
gEDA-user: trace optimizers cause abort
- To: geda-user@seul.org
- Subject: gEDA-user: trace optimizers cause abort
- From: Bob Paddock <bpaddock@csonline.net>
- Date: Sun, 17 Aug 2003 08:22:52 -0400
- Delivered-to: archiver@seul.org
- Delivered-to: geda-user-outgoing@seul.org
- Delivered-to: geda-user@seul.org
- Delivery-date: Sun, 17 Aug 2003 08:23:21 -0400
- Organization: The Designer-III Company http://www.designer-iii.com/
- Reply-to: geda-user@seul.org
- Sender: owner-geda-user@seul.org
- User-agent: KMail/1.5.2
I compiled the latest CVS version (Aug/17) of PCB, then
loaded the tutorial tut1.pcb, then did "auto-route all rats".
Which worked, there was no DRC errors.
However when I try any of the optimizations I get this:
"djopt: simple
layer 6
Aborted"
where I'm returned to the command prompt.
Being new to PCB can some one tell me what I'm
doing wrong, please?
--
http://www.softwaresafety.net/
http://www.unusualresearch.com/ http://www.bpaddock.com/