gEDA-user: PCB Command Entry

[ST de Feber <stdf23173@xxxxxxxxxxx>]

Hello List

I was not too happy with the drill sizes and pads of some components and found a solution in the archives by using the 
command line entry.
Problem 1 : The drag down box does not show me the available commands
Problem 2 : The following command did not seem to have any effect:
>>                 :ChangeDrillSize selectedpins =43 mil


As reported earlier , i also have problems using the shift-left-mouse-click to replace components.
My PCB crashes.

Could the be related to install problems ?


grtz

Simon


----- Original Message ----
From: Steve Meier <smeier@xxxxxxxxxxxxxxxxxxx>
To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sent: Sunday, 26 August, 2007 3:36:06 PM
Subject: Re: gEDA-user: novice enquiry

gschem is suitable for most schematics, it does have limitations in
certain advanced usages.

Steve Meier

DJ Delorie wrote:
>>      Is gschem suitable?
>>     
>
> Yes.
>
>   
>>      If so, how do I go about downloading it?
>>     
>
> http://www.geda.seul.org/download.html
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>   



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user





      ___________________________________________________________ 
Want ideas for reducing your carbon footprint? Visit Yahoo! For Good  http://uk.promotions.yahoo.com/forgood/environment.html


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user