gEDA-user: Trouble with a footprint

I'm having trouble defining a footprint for a 1206 smt reverse mounted led.  My trouble is defining the footprint to the spec yet maintaining 4pcb's footprint requirements.  If I understand this footprint I think I'll be able to define mine.


Here's the one I got from geada symbols:

Element["" "" "" "" 157480 59055 0 0 0 100 ""]

Pin[0 0 13000 2000 13600 11811 "" "1" "edge2"]
Pad[-11811 0 -9842 0 4000 5600 9600 "2" "2" "square"]
Pad[9843 0 11811 0 4000 2000 6000 "1" "1" "square,edge2"]
ElementLine [-6693 -5118 -6693 5118 1000]
ElementLine [-8858 -7874 -8858 -2953 1000]
ElementLine [8858 7874 8858 2953 1000]
ElementLine [1181 0 -1181 0 600]
ElementLine [-8858 7874 8858 7874 1000]
ElementLine [-8858 2953 -8858 7874 1000]
ElementLine [8858 -7874 8858 -2953 1000]
ElementLine [8858 -7874 -8858 -7874 1000]
ElementLine [0 -1181 0 1181 600]

)


This defines a reverse mounted led.  I got this from http://www.gedasymbols.org/user/kai_martin_knaak/footprints/specific/BPW34S_upsidedown.fp


From this aren't the pads inside, or on, the hole created by the pin?  Wouldn't the annular short the pads?  How I read this is, you have a 6 mil thick annular with an inside diameter of 130 mils.


Also, the way I understand the mask isn't the mask inside, or on, the annular?