[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: gsch2pcb stuck

To: "gEDA user mailing list" <geda-user@xxxxxxxxxxxxxx>
Subject: gEDA-user: gsch2pcb stuck
From: "Robert Butts" <r.butts2@xxxxxxxxx>
Date: Sun, 17 Aug 2008 18:18:26 -0400
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Sun, 17 Aug 2008 18:18:40 -0400
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

I'm trying to run a very simple schematic thru gsch2pcb and it's getting stuck. The printout says: using the m4 processor for pcb footprints

Then just sits there. The footprints I'm using are TO-18 AND DO-35. Aside from that it's just a thru hole definition. Any ideas?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: gsch2pcb stuck
  - From: phil

Prev by Author: gEDA-user: best ways to do SMT assembly
Next by Author: Re: gEDA-user: gsch2pcb stuck
Previous by thread: Re: gEDA-user: Renaming "ben mode"
Next by thread: Re: gEDA-user: gsch2pcb stuck
Index(es):
- Author
- Thread