Re: gEDA-user: dbus connection error

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-08-27 at 06:26 +0100, ST de Feber wrote:
> Hello All,
> 
> I have installed the binary release of gEDA on a RH
> machine. gschem works OK but when starting PCB i get :
> 
> >>pcb_dbus: DBus connection Error (Failed to connect
> to socket /tmp/dbus-PAROTiGphM: Connection refused)

Old RH machine? Sounds like you might not have a DBus session running.
I'm not sure if the binary distribution tries to start one or not. That
error shouldn't affect running speed, but might take a little while
before the timeout appears.

> and it is terribly slow. 

What exactly is slow - does it take a while for the above timeout, or is
PCB just slow generally?

> I checked the wrapper script but could not find any
> clue on this error.

Try "dbus-launch pcb".

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user