Re: gEDA-user: Turning off gerber Poly Fill for square pads

[Thomas Olson <tolson@xxxxxxxxxx>]

On Thursday 20 August 2009 02:51:41 pm DJ Delorie wrote:
> > The issue is that isolations programs like CopperCAM and GCAM
> > ignore the G36 G37 commands and thus draw the pad as 4 traces
> > in a sqaure shape and then isolating the inside of the pad because
> > it thinks they are traces.
> >
> > They draw those four lines using the last defined aperature so the
> > pad ends up being too large besides.
>
> In other words, they're broken and it's our fault?
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Dude! No one is blaming fault on PCB. It is obviously the other guys
fault for not implementing all the R274X features properly. Just asked a 
simple question needing your simple answer which you gave nice
and quickly. Thanks.
   


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user