gEDA-user: PCB problem - bug?

["Harold D. Skank" <skank54@xxxxxxxxx>]

People,

I'm using the PCB package from the 20060907 gEDA disk release (thanks to
Stuart Brorson).

In the course of my current design effort, I elected to move some bypass
capacitors to the back side (solder) of the board.  No problem so far.

When I routed the board I found that router was attempting to connect to
the bypass caps as though they were on the front (component) side of the
board.  While I can correct these problems manually, even the DRC
checker thinks the pads are on the component side of the board, and
complains accordingly.

Now, is this a bug (possibly already corrected) or am I seeing some kind
of installation problem?  If it's an already corrected bug (I seem to
remember a host of complaints following this release) where can I
download the updated pcb files?

	Harold Skank



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user