[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: DRC error

To: geda-user@xxxxxxxxxxxxxx
Subject: gEDA-user: DRC error
From: "Saritha Kalyanam" <kalyanamsaritha@xxxxxxxxx>
Date: Wed, 31 Dec 2008 17:17:20 -0800
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Wed, 31 Dec 2008 20:17:27 -0500
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

   The following footprint gives a DRC error "copper areas too close"
   [1]http://www.gedasymbols.org/footprints/m4lib/LQFP48_7.fp
   The pads are most likely 9 mils apart instead of 10 mils.
   Saritha

References

   1. http://www.gedasymbols.org/footprints/m4lib/LQFP48_7.fp


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: DRC error
  - From: DJ Delorie
- Re: gEDA-user: DRC error
  - From: John Luciani

Prev by Author: gEDA-user: gedasymbols.org - site down?
Next by Author: Re: gEDA-user: pcb: parameter escaping for commands
Previous by thread: Re: gEDA-user: pcb anti-environment coating?
Next by thread: Re: gEDA-user: DRC error
Index(es):
- Author
- Thread