gEDA-user: Drawing lines (schematic editor)

["Johnny Rosenberg" <gurus.knugum@xxxxxxxxx>]

I installed the gEDA schematic editor (and other gEDA stuff) yesterday and  
played around with it a bit today and as a beginner I have a few  
questions, here's one of them (I already asked one in another thread a few  
minutes ago):

When I connect things to each other I enter the âadd nets modeâ, right? So  
for testing, I first added an ordinary OP amp and then I wanted to draw a  
line between the output and â-â to create a âfollowerâ, it that the right  
word in English? But no matter what I did in add nets mode, the (blue)  
line went right through the OP amp, which doesn't look very good in my  
opinionâ How do I prevent this from happen?

Sorry for not so good Englishâ
--
Kind regards

Johnny Rosenberg


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user