Re: gEDA-user: ngspice problems

[Peter Kaiser <peter@xxxxxxxxxxxx>]

>
> There's a 10ohm resistor as load, I = V/R = 200/10 == 20A?(assuming DC) I'm
> not sure how the diode bridge affects this, but 2A seems a little bit low
> to me.

In the email you sended yesterday there is a 100 Ohm resistor:

* Load resistance
ROUT 4 0 100

> In interactive mode I plotted I(1) and I(2), and they varied between 0 and
> 200, which is sortof what I would expect, seeing as the output is not
> really DC.
>
> > May be the value V(1,2) is not covered by the command ".save all".
> > Could you try ".save V(1,2) or may be the "define" command together
> > with .control.
>
> .save V(1,2) just saves V(1) and V(2) into the raw plot.
> I don't know how to use those define and .control things.

Unfortunalty that's almost not documented. As far as I know, it's quite easy. 
Just take the command as used in interactive mode and put them 
between .control and .endc.


Peter